HY25-3000/US

Power Take-Off Worksheet
Applications

General Safety Information

power-takeof-request-quote
1. Make and Model of transmission (*)

Invalid Input
2. Type of driven equipment

Invalid Input
3. Input horsepower required of driven eqipment

Invalid Input
4. Desired operating speed driven equipment

Invalid Input
5. Approximate engine speed desired during operation.
Figure the equipment speed expressed as a percentage of the desired engine speed during the duty cycle.
Driven equipment + Engine speed = App. P.T.O.%

Invalid Input

6. Direction of driven equipment shaft rotation in relation to direction of engine rotation (Check One).

Opp.
Invalid Input
Eng.
Invalid Input

7. Type of connection between P.T.O. and driven equipment (check one)

Driveshaft
Invalid Input
Directmount
Invalid Input
Pulleys and belts (requires eng. approval)
Invalid Input

8. Mounting Location (check all suitable locations)

Left
Invalid Input
Right
Invalid Input
Bottom
Invalid Input
Top
Invalid Input
Countershaft
Invalid Input

9. Duty cycle (check one)

Intermittent
Invalid Input
Continuous
Invalid Input
10. Other P.T.O. speeds or reverse gear requirements

Invalid Input
Captcha:
Captcha:
  Refresh
Invalid Input

  
11. Application page number for make and model of transmission

Invalid Input
12. From items 3 and 4 determine the intermittent torque requirements of the driven equipment using this formula:
(HP*5252) % R.P.M = Lbs. ft.
T= Lbs. Ft. (intermittent)
Invalid Input
13. If torque requirements are continuous (more than 5 minutes operation every 15 minutes) divide the torque figure by .7. The result will be the torque required for continuous operation.

Invalid Input
Determine What Options are needed and change model prefix and suffix to obtain correct options. (See Model Number Construction in section 3)

Invalid Input
Find the P.T.O. in the HY25-3000/US catalog that meets the torque, rotation, and speed percentage requirement of the application. Note the P.T.O model number and all numbers of mounting parts on ethe lines below.

Invalid Input